Home
Index
Page
More
of the Model
The
Math
Construction
Begins
Trim
Tabs & Control Horns
Fuselage
Construction1
Aft
Controls-Misc
Aft
Fuse & start Center Section
Cabane
& Center Section
Cross
Bracing & Land Gear
Wing
Spar & On the Gear
Bottom
of Fuse & Eng.Mount
Windscreen
& Start Wings
Top
Right Wing
Upper
Wings & Fuel Tank
Fuel
Tank & Brakes
Other
Airplanes-Misc.
Building
Lower Wings
Ailerons-Wings-Struts
Final
Assembly-Carb Heat
Cowl
Finished
Cowl
Odds
& Ends
Get
Ready to Cover
Covering
& Painting
More
Finish Work
Painting
& Assembly
Final
Assembly
Final
Assembly (cont)
The
Final Verse
My Book
|
Top
Row
Photo #1,2,3 -Most
of the basic painting on the fuselage is now done. Came out pretty
good.
Photo #4,5 -My
attempt at lettering. I first printed out the lettering on my computer,
stuck that to sticky shelf paper, cut out the letters and applied them
to the fuselage, then painted red over them. Then removed them.
Came out pretty good but had to tidy up the edges with my xacto knife as
they were a little ragged.
Bottom Row
Photo #1 -Left
side is now finished. It was all hand done using a DecoColor (tm)
paint pen. Later found out it was ink rather than paint so had to go over
all of it with paint.
Photo #2 -Had
to try shadowing of the N number. Worked out OK if you don't look
real close.
Photo #3 -The
wheel pants make this airplane, so had to attach them, although will leave
them off for the test flights.
Photo #4 -Time
to start putting it back together and see what it looks like. Hoping
for an August/Sept (05) test flight.
Photo #5 -Engine
mounted but not hooked up.
Previous
Page
Next Page
Index Page
|
